BAOFENG UV-82 Programming a Repeater Channel with any offset (Standard or Odd Split)

Programming a Repeater Channel with any offset
(Standard or Odd Split)

This example is for:  146.700 MHz
600kHz minus offset
into channel 99
CTCSS tone 123.0 (optional)

1.    Set radio to VFO Mode (Frequency Mode)
      a.)     UV5R series - Press VFO/MR button
      b.)     UV82 - Turn radio OFF, then Press/Hold MENU button during PowerON.

2.    Select   Display A    (this is a must)
      a.)     UV5R - Press     [A/B]      and select the Upper Display.
      b.)     UV82 - Press [EXIT A/B] and select the Upper Display.

3.    Disable TDR (Dual Watch/Dual RX) which toggles between A and B.
          Press  [Menu]   7   [Menu]
          Select OFF
          Press  [Menu]   [Exit]

4.    Delete Prior Data from the channel to be programmed.
          Press  [Menu]   2 8   [Menu]
          Enter   9 9   (Memory Channel  to clear)
          Press  [Menu]   [Exit]

5.    Store RX frequency
          Enter    1 4 6 7 0 0
          Press  [Menu]   2 7   [Menu]
          Enter   9 9   (Memory Channel)
          Press  [Menu]   [Exit]

6.   Set CTCSS or DCS codes for Transmit.  (if needed)
         ( example = CTCSS TX tone 123.0 Hz )
            Press  [Menu]   1 3   [Menu]
            Enter  1 2 3 0   [Menu]   [Exit]

7.    Store TX frequency
          Enter   1 4 6 1 0 0
          Press  [Menu]   2 7   [Menu]
          Enter   9 9   (Memory Channel)
          Press  [Menu]   [Exit]

8.    The split is now programmed.



This procedure can be used to program standard offsets as well cross band.
If you know the repeater's RX and TX, you can program them separately without using the repeater offset menus.

SUMMARY of above
RX 146.700,  TX 146.100
tone 123.0 optional


1.       Set radio to VFO Mode   (Frequency Mode)

2.       [EXIT A/B]   must be set to Upper Display.

3.       Turn TDR OFF
          [Menu]    7    [Menu]   OFF   [Menu]   [Exit]

4.    Delete Prior Data
          [Menu]   2 8   [Menu]   Ch No. (99)   [Menu]   [Exit]

5.    Store RX frequency into channel
          1 4 6 7 0 0   [Menu]   2 7   [Menu]   Ch No.   [Menu]   [Exit]

6.   Set TX CTCSS or DCS codes for Transmit.  (optional)
        [Menu]   1 3   [Menu]   1 2 3 0   [Menu]   [Exit]

7.    Store TX frequency into channel
          1 4 6 1 0 0   [Menu]   2 7   [Menu]   Ch No.   [Menu]   [Exit]


Switch to Channel Mode. (MR)